I like to run a test print before I start posing a model, just to see where the problem spots are going to be. Consumer-level printers like the Replicator are hindered by gravity and overhangs; one can’t print too far out into empty space without the melted plastic drooping and bunching up.
The base pose for the Beast isn’t too bad, but I can see that I’m going to need to angle the head and chest up so that the printer creates its own support as it prints.
The long filament coming off the back of the base is leftover from the printer clearing its nozzle at the start of a print.
You can download the completed model here, completely free.
No printer? I’ll print you as many as you need at my Etsy Store. A half-dozen should do it for most games.
This model is distributed under the Attribution-ShareAlike 3.0 US license. Please remix and enjoy.